KRYDEX USPSA 1.75-inch Belt Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The KRYDEX USPSA mag holster backing to fit thicker 1.75-inch battle belts!
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 808
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This KRYDEX USPSA mag holster only fit 1.5-inch belts and couldn't find ones for my thicker 1.75 inch battle belt that I normally use, so I designed my own backing that accommodates thick belts.
You'll need 4x 14mm M3 bolts for each back, as well as 4 x M3 nuts. (since the back is now longer/thicker the original screws won't work)
I suggest using a bit of blue Loctite on the bolts but it is pretty tight as it is so up to you!
Printed in PLA+ at least, 4+ walls, 0.2mm layer height, 100% infill, support on build plate only for the nut holes on the bottom.