BLTouch Holder, multiple lengths. Fits many printers. Two Trees Sapphire Pro / Plus (SP-3, SP-5)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the BLTouch sensors. Several lengths are included to match variance. Perfect fit on Two Trees SP-3 and SP-5
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The Two Trees SP-3 and SP-5 comes with mounting holes near the hotend that allows users to attach a BLTouch sensor. This requires you to print a small bracket to hold the sensor.
However, While the BLTouch sensor and clones all seem to have identical mounting holes, it seems they come in a number of length variance. This is problematic as they have pretty strict tolerances for mounting heights.
The sensor I got required to have a bracket with a length of 18mm from center of mounting hole to bottom of the bracket that held the sensor, and every model I found was at least 1 mm off.
Hence i have included various lengths from 13-20mm. I believe the most commonly used is 19mm. This should be your first try. 13-14mm is slightly thicker as it will else be close to fan on SP-3 and SP-5
Be aware, that you should aim at getting the sensor as far from the build plate, while still functioning, if it is mounted too low, a bit of warping in your print might hit the probe and damage it. Better lift it a bit within tolerance.