1 / 3
CW2 Meowburner ECAS w/ Filament Switches (Updated Main Body) — zdjęcie 1
1 / 3

CW2 Meowburner ECAS w/ Filament Switches (Updated Main Body)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Meowburner with ECAS and filament runout sensor.

Ocena
0 / 5
Polubienia
7
Pobrania
36
Wydruki
0
Wyświetlenia
332
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Updated version of https://www.printables.com/model/454548-cw2-meowburner-ecas-w-filament-switches with the 1.0 CW2.

BOM is unchanged:

  • 1x Omron D2F or compatible
  • 5.5mm ball
  • 2x self-tapping screw M2x10 or M2x8
  • Bondtech Push-Fit ECAS 4mm or compatible

I also tested this with a toolhead PCB, which might require some fiddling and bending of the switch pins but works just fine.

The ear accents can be either glued in place or presumably printed with a multi-material capable printer.

Using a switch with a lever (recommended):

The original bom states a switch without a lever. Like another user in the comments of the original filament runout design, I fonud that using a switch without the lever can lead to issues with consistently detecting flexible filament. I strongly recommend using a switch with a lever in the opposite orientation.

The end of the switch will have to be clipped and bent carefully to get consistent activation.

  • Try to clip the lever in about the spot where it would meet the ball. Make sure to leave enough material where the lever splits so it doesn't fall apart. The gap at the end acts as a spring to hold the lever in place!
  • If after inserting the switch doesn't deactivate (you don't hear a click), take out the switch (see below), and bend the lever at the end carefully just a bit. You may have to remove the lever from the switch to get enough leverage. Hold the end with pliers and push down on the lower part carefully, as to not bend it too much. Repeat until filament insertion and removal gets you a solid click.
  • Make sure you test the click on insertion/removal with the screws in place. The screws change the exact position of the switch.

During this you will likely have to insert and extract the switch multiple times:

  • Use a small hex wrench through the gap to push the switch out. A small enough wrench can be positioned diagonally and used as a lever to completely push out the switch.
  • You can also use tweezers to push the switch out far enough for the screw holes to be accessible. You can use these to pull out the switch. Pulling too hard can damage the switch!

An example configuration with the SB2209/RP2040 CAN board:

[filament_switch_sensor tool_0_filament]
pause_on_runout: true
insert_gcode:  
   G92 E0 ; Reset Extruder
   G1 E50 F600 ; move filament down 50mm quickly
   G1 E50 F300 ; purge
   G1 E50 F300 ; purge
   G1 E50 F300 ; purge
event_delay: 3.0
pause_delay: 0.5
switch_pin: EBBCan:gpio24

Tagi