V-Core 3.1 120mm Bed fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blows a lot of air directly at the bed which is useful for chamber soak and bed cool-off
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 334
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This uses Noctua's fan duct geometry https://www.printables.com/model/887071-nv-aa1-12-airflow-amplifier which is attached to frame and pointed at bed.
Duct is cut so that full bed travel is not limited. The lower the fan is the better - I'm not sure how much clearance in Z axis there is. It should be 10 mm but….
Best bed position is around Z= 250 - 300 mm
Tightening the M6 bolt to 3030 extrusion is a bit of a pain but it's possible. Worst case tighten just the front bolt - it should be fine.
Can be printed without supports if you'll survive the one small area with a few unattractive layers before the print catches back on.