Kulp K8-Pi PSU Mount

Works with any of the very common 215x115x30mm platform PSUs, like the CUI VGS-350C, Meanwell LRS350, Mornsun LM350, and others.

Recommended hardware:

• 2 - m4 x 8mm screws to mount the bracket to the PSU.
• 4 - m3 x 6mm screws
• 4 - m3 nuts
• 4 - m3 x 20mm+6mm standoffs.
• 8 - m2.5 x 4mm screws
• 4 - m2.5 x 11mm female to female standoffs

1. Insert the m3 nuts into the pockets and screw in the m3 20mm standoffs from the other side. The standoffs will pull the nuts into the pockets.
2. Install the bracket onto the front mounting holes of the PSU. There is a 1.5mm open slot in the bracket above the mount holes to allow for mounting flanges to be installed if desired.
3. Install the m3 x 11mm standoffs onto you RPi, and then attach it to the K8-Pi.
4. Attach the K8-Pi to the bracket.
5. Wire it up and enjoy.