1 / 5
Kulp K8-Pi PSU Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount the Kulp K8-Pi to the top of your PSU.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 58
- Makes
- 0
- Views
- 296
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Works with any of the very common 215x115x30mm platform PSUs, like the CUI VGS-350C, Meanwell LRS350, Mornsun LM350, and others.
Recommended hardware:
- 2 - m4 x 8mm screws to mount the bracket to the PSU.
- 4 - m3 x 6mm screws
- 4 - m3 nuts
- 4 - m3 x 20mm+6mm standoffs.
- 8 - m2.5 x 4mm screws
- 4 - m2.5 x 11mm female to female standoffs
- Insert the m3 nuts into the pockets and screw in the m3 20mm standoffs from the other side. The standoffs will pull the nuts into the pockets.
- Install the bracket onto the front mounting holes of the PSU. There is a 1.5mm open slot in the bracket above the mount holes to allow for mounting flanges to be installed if desired.
- Install the m3 x 11mm standoffs onto you RPi, and then attach it to the K8-Pi.
- Attach the K8-Pi to the bracket.
- Wire it up and enjoy.