1 / 4
Aluminium reinforced MM Y Motor mount / Heat sink — zdjęcie 1
1 / 4

Aluminium reinforced MM Y Motor mount / Heat sink

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A aluminium reinforced Mendelmax Y Motor mount, this uses a 58mm long bit of of 40x40x3 Aluminium 90 Angle to add a…

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
199
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

A aluminium reinforced Mendelmax Y Motor mount, this uses a 58mm long bit of of 40x40x3 Aluminium 90 Angle to add a bit of strength, also acts as a heat sink.

Print instructions

Category: 3D Printer Parts Instructions

Print with support.
Insert Aluminium and re-drill holes.
Drill or otherwise remove a hole for the Stepper Spindle
Trim excess Aluminium if desired or if your using the 'tail'.

This printed fine, but needed a lot of clean up due to support (PLA support sticks to well)

Scad code is provided, as is where is (Ie the code is crap, but works)

NB Aluminium is a very tight fit, a small amount of sanding of plastic is required.

Tagi