1 / 4
Aluminium reinforced MM Y Motor mount / Heat sink — image 1
1 / 4

Aluminium reinforced MM Y Motor mount / Heat sink

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A aluminium reinforced Mendelmax Y Motor mount, this uses a 58mm long bit of of 40x40x3 Aluminium 90 Angle to add a…

Rating
0 / 5
Likes
1
Downloads
18
Makes
0
Views
199
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

A aluminium reinforced Mendelmax Y Motor mount, this uses a 58mm long bit of of 40x40x3 Aluminium 90 Angle to add a bit of strength, also acts as a heat sink.

Print instructions

Category: 3D Printer Parts Instructions

Print with support.
Insert Aluminium and re-drill holes.
Drill or otherwise remove a hole for the Stepper Spindle
Trim excess Aluminium if desired or if your using the 'tail'.

This printed fine, but needed a lot of clean up due to support (PLA support sticks to well)

Scad code is provided, as is where is (Ie the code is crap, but works)

NB Aluminium is a very tight fit, a small amount of sanding of plastic is required.

Tags