Electronics Mounts with Magnets (RPi4B, SKR1.4, EXP-MOT, Step down Module, Cooling Fans)

!!!!! The printed parts are not verfied yet ! !!!!!

!!!!! I just made this page in advance before last verification of 3d files !!!!!

These are mounts for electronic parts in a typical Klipper hardware setup.

There are :

1. Raspberry Pi 4B Mount
2. SKR 1.4 Mount (with additional fan mount)
3. BTT EXP-MOT Mount (with additional fan mount)
4. SKR 1.4 + EXP-MOT Mount (with additional fan mount)
5. Step-down Module Mount *
6. Will be updated : BTT U2C module

You will need :

• Four 3 x 4 x 5mm (ID x Height x OD, M3 insert) inserts for each corner of every mount.
• Four 6 x 4mm (Diameter x Height) magnets for each corner of every mount, except six for the SKR 1.4 + EXP-MOT Mount.
• Two 4010 fans for the fan mount.
• Two 6 x 4mm magnets for the fan mount.
• M3 screws and nuts as required for each mount.

When you print :

• Areas where magnets will be installed require supports. However, since these are small parts, supports may not be necessary if your cooling settings are adequate. Without supports, there might be precision issues when inserting magnets due to minimal height tolerance.

• The fan mounts are divided into three pieces to avoid the need for supports during printing. You need to print Part C three times and glue all the pieces together.

• Each fan mount has a different height, so it is not compatible with other mounts. Just pay attention to its name. (ex. “SKR 1.4+EXP-MOT Mount" +  “Fan Mount for SKR 1.4+EXP-MOT” = OK / “SKR 1.4+EXP-MOT Mount” + "Fan Mount for SKR 1.4 or for EXP-MOT” = No)

• *Note: The step-down module mount may not be compatible with all step-down modules on the market. You might need a different mount that fits your specific module.