Nissan Dash Tray with Phone Holder

Replacement dash stray with a phone holder for Nissan Xterra 2005-2013/Pathfinder 2005-2010/Frontier 2005-2017.

Please verify that you have rounded dash top around the tray! Does not work with models that have higher trim and tray with flat shape.

Front edge of the storage box has a groove for a phone. Center of the groove has a fillet to make more screen visible while phone is placed horizontally. This enables better view while using navigation and ensures usability of the phone. If a phone is placed vertically, it should be pushed to the side of the groove to have a good support from non-rounded bit to avoid phone falling during acceleration.

Pictures: 

• The black tray is printed in flat orientation using TPU with 0.2 mm layer height. 
  • This is the easiest print orientation, support are recommended.
  • This part doesn't have to be printed with TPU, rigid materials will also work and fit.
• The green tray is printed in flat orientation using PLA with 0.2 mm layer height. 
  • Note: This print was the final mockup to check fitment before printing the part in TPU, I do not recommend PLA for car interior use.

Note: It may be possible to print this part on it's side to improve top surface quality. I printed some of the earlier iterations with the part turned on its side without supports in the larger tray area. This caused minor drooping and worse quality in the walls of the box, so I opted for flat orientation. You may have better results if you have a better printer and/or don't use TPU.