Hexagonal screw box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Box to hold small screws or similar tiny objects up to length of ~34mm/1.33 inch long.
- Ocena
- 4,75 / 5
- Polubienia
- 64
- Pobrania
- 338
- Wydruki
- 4
- Wyświetlenia
- 2491
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I needed some organizer for a lot of screws and I liked hexagonal ones posted around on this site and/or thingiverse. Unfortunately they were mostly too small for my needs, so I designed my own.
As you can see in photos it can hold quite big amount of small screws.
Printed in PETG, 0.2mm layer height.
Lid is a little tight at the beginning, start opening/closing it on one side and progresively get to the other side. After a few tries it gets easier, but it stays firm. Alternatively you can brush the lid's edges a little, but be careful not to overdoing it.
Also it's best to print the Lid upside down, otherwise you will need a lot of supports or huge overhangs.
Enjoy :)