Hexagonal screw box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Box to hold small screws or similar tiny objects up to length of ~34mm/1.33 inch long.
- Rating
- 4.75 / 5
- Likes
- 64
- Downloads
- 338
- Makes
- 4
- Views
- 2,491
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
I needed some organizer for a lot of screws and I liked hexagonal ones posted around on this site and/or thingiverse. Unfortunately they were mostly too small for my needs, so I designed my own.
As you can see in photos it can hold quite big amount of small screws.
Printed in PETG, 0.2mm layer height.
Lid is a little tight at the beginning, start opening/closing it on one side and progresively get to the other side. After a few tries it gets easier, but it stays firm. Alternatively you can brush the lid's edges a little, but be careful not to overdoing it.
Also it's best to print the Lid upside down, otherwise you will need a lot of supports or huge overhangs.
Enjoy :)