1 / 1
First Layer Calibration Creality Ender 3 / Pro
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Better Way to perfectly set your first layer Z. 3MF files and Pre-sliced Gcode for different materials.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 1450
- Wydruki
- 1
- Wyświetlenia
- 7335
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (78)Powiązane
Thank you to GKMAKEIT for the original. I found this so helpful at getting the perfect first layer setup that I found myself using for all different types of materials - I have now remixed it for use on my Ender 3.
In Summary, you adjust your babystep Z during the print until you get a good looking first layer.
This version is tested with an Ender 3 and Ender 3 pro, without an auto bed leveler.
Step by step guide:
- Level your bed with some decent accuracy
- Clean your build surface thoroughly
- Run your Gcode file and be ready to babystep Z ( Menu → Tune → BabystepZ )
- Raise the babystep Z significantly, so that you aren't gouging the nozzle into the build surface
- As the printer is running the purge line and the skirt, adjust the Z so that your print is sticking decently onto the surface. If any extruded material comes lose, remove it before the perimeters of the print start.
- Once the inner lines start, Give it about 10 passes on each Z-offset setting, then adjust down or up accordingly. I typically use 0.050mm or 0.025mm adjustments
- I Suggest writing the babystep Z adjustments you make for each section on the side with a sharpie so you can refer to your previous adjustments during the print
- Once the print is over, navigate to the configuration menu and SAVE YOUR SETTINGS - Otherwise the babystep Z that you did will NOT be saved.