FlySky FSi6x Transmitter Gimbal Guards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gimbal Guards for the FlySky FSi6X (and probably the FSI6) transmitter. V5 is my best iteration so far.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 263
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
V5 of the Gimbal Guard is the one you should be printing, I've uploaded the other versions to show the iterative process I went through.
V1 worked, but was terrible to remove, and was mainly to confirm my measurements.
V2 was nice to remove, but got in the way of the lanyard. The bar I used to connect the two sides was aesthetic but used more supports than it should and was very fragile.
V3 moved the support out of the way of lanyard and made it stronger, but now it was hard to remove again.
V4 was almost the best! I added a thumb cutout to make grabbing and pulling them off easier, but then after using them for a while I noticed that the ergonomics were just wrong.
V5 corrected the grip, and I added a fillet on the bottom opening to make it easier to locate
Print with supports.
Amazon Link for the FlySky FSi6x: https://a.co/d/0TJ3UrY