1 / 2
Short joystick extension for VPforce Rhino or thrustmaster compatible sticks — zdjęcie 1
1 / 2

Short joystick extension for VPforce Rhino or thrustmaster compatible sticks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This extension is a little under 50mm tall, bring the stick forward by 33mm and tilts it 10 degree forward.

Ocena
0 / 5
Polubienia
9
Pobrania
76
Wydruki
0
Wyświetlenia
464
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution

This extension is a little under 50mm tall, bring the stick forward by 33mm and tilts it 10 degree forward.

There is a version of the extension with and one without access hole that may help if you have a thick/long connector. Also helpful when printing with organic supports

I included an adapter for generic/TM compatible bases, I did not test that, I only tested the rhino adapter. 

You need to glue the adapter in the extension, it will clamp the nut and allow it to turn. Its a tight fit and a few drops of CA glue will make it stronger than you think.

I printed mine in PLA with the exception of the nut, I printed that in PETG as its the weakest part. Use 100% infill for that part and for the adapter. For the extension itself, I used 4 perimeter walls and 50% infill, seems strong enough. 

I remixed the knurled nut and adapter from here:

https://www.thingiverse.com/thing:3625918/files

 

Tagi