1 / 18
Two speed transmission for big model of car / truck / crawler / tractor / vehicle — zdjęcie 1
1 / 18

Two speed transmission for big model of car / truck / crawler / tractor / vehicle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Custom made two speed transmission for any model of vehicle where it actually fits :D

Ocena
0 / 5
Polubienia
9
Wydruki
0
Wyświetlenia
455
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Standard Digital File License

!!!!!!BEFORE PRINTING note that there are a few pieces (two) that require to be made from metal!!!!!

Hello there, 

you can print whole model with classic PLA.
Model is optimized for printing. It works wonders and has been tested in the worst conditions (snow, leaves, mud, forest ground, branches,….)

There are two speeds: high and low.

To transfer the torque from the transmission use drive shaft with outer diameter not greater then 11mm. inner diameter is 5mm (as the axis)

Required parts:
Motors: 
Motor RS750-9024 DC 9.6V PARKSIDE
classic 9g servo motor (could be the one with plastic gears).
bearings (8x): 6x 6x10x3, 2x 5x10x4
metal axis used (2x): d 5mm x 92mm, d 6mm x 108mm
headless screws used(9x for fixing gears): m2.5x16 mm
retaining rings used(4x): 2x m5, 2x m6 (transmission will work without them too, but slightly worse)
screws: 
2x m4x10
4x m3xX(transmission holder)
2x m3x8(max)(used to close the transmission after you lock the gear to the axle)
4x m2.5x16 (you can use those almost everywhere (m2.5) you can't use them where you connect the transmission holder to the transmission → 6x)
8x m2.5x10
16x m2.5x8
2x m2.5x12
nuts:
7x m2.5
3x m6xX(used for lubricating the gears)
knurled nuts:
6x m2.5 length 2.5mm OD 3.2mm
12x m2.5 length 3mm OD 3.5mm (can be used instead of those above)

More information is in the Read This document bellow. Happy printing :D

Tagi