Whitlock cobra clamping housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A model to house the clamping assembly in on a cobra whitlock
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Withlock steering pedestal lock
The clamping device on this cobra whitlock failed. SV Lotus reached out to me to see if I could get this fixed. Not only did we make a new part we improved the design for extra strength. The broken part was also printed and clearly not up to the task.
Part was printed with 12 perimeters and 50% infill. Original hardware was used. The housing and the clamp itself is printed.
There is a recess in the clamp for an M8 nut.
Disclaimer
My models are always tested on boats. We are currently cruising to the Caribbean and you can therefor assume that we load up the part properly. It is however your own responsibility to use these parts when heading out to sea. Use common sense and print spares if you are not able to print onboard. Especially on longer passages.
Remix
Please remix however you like. If you are not able to design your own parts I do offer a modification service to those in need. A contribution for my effort is however expected. Send me a message on Noforeignland and I am sure we will figure something out.
https://www.noforeignland.com/boat/sya