1 / 2
Anti-roll foot / mini stand for Pinecil soldering iron — zdjęcie 1
1 / 2

Anti-roll foot / mini stand for Pinecil soldering iron

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A small but very effective anti-roll foot and mini stand for the Pinecil.

Ocena
0 / 5
Polubienia
9
Pobrania
50
Wydruki
0
Wyświetlenia
269
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Updates

  • 11/2024: Added a “wide” version with 50% wider base. This is what I use now on my Pinecil and what I would recommend.

 

Description

A small but very effective anti-roll foot and mini stand for the Pinecil. It simply clips on and allows the iron to sit on your workbench without rolling around or tipping over. The foot does not interfere with changing soldering tips.

Available in default height (as pictured), as well as in a short and a tall version (-1.5 mm and +1.5 mm height). Scaling the model by +-0.75% in X and Y direction changes the main hole diameter by +-0.1 mm.

I'm using this on my Pinecil V2. It is technically not tested with the V1, but it should fit as well. According to Pine64, the shells of the Pinecil V1 and V2 are interchangeable.

 

Print settings

  • Layer height 0.2 mm
  • Line width 0.42 mm
  • 3 wall lines
  • 5 top & bottom layers
  • Supports not required

Material should be one with a heat deflection temp of ≥65°C. PETG works fine on my iron, PLA will likely get soft and bend when in use.

Approximate print time @ 60 mm/s: 0:10 h

Tagi