1 / 3
Horizontal Spool Lazy Susan with 608 Bearing, No Support — zdjęcie 1
1 / 3

Horizontal Spool Lazy Susan with 608 Bearing, No Support

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Filament-go-round

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
280
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Bought some super cheap plastic storage (not an affiliate link) at Dollar Tree with the intention of using them at single-spool stackable storage that I could dump some desiccant in. Needed some sort of lazy Susan to be able to feed filament out a side wall. Spools did not fit in the bottom of the container well, so I needed to lift them up a little as well. Somewhat unrelated, I intend on getting some weather stripping or paint-on sealant to create a gasket for the lid for a better seal. 

Uses a single 608 bearing (not an affiliate link) & does not require support to print. 

I have only started 3D printing in the last couple weeks and I have zero knowledge of how to work with CAD. This was all clumsily edited in a slicer. Please don't ask me technical questions lol

I printed it in Elegoo Rapid PLA, 0.2 layer height, 15% infill, changed from 3 walls to 2 after printing the plate and spool to save a minute or two. I don't think it matters much considering the use case. 

The spool/plate only fit together in one way as the pegs are not equally spaced :D 

Anyway, it works well, and it works even better if you put it in a container that's a litter less restrictive. 

Tagi