Horizontal Spool Lazy Susan with 608 Bearing, No Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament-go-round
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 19
- Makes
- 0
- Views
- 280
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
Bought some super cheap plastic storage (not an affiliate link) at Dollar Tree with the intention of using them at single-spool stackable storage that I could dump some desiccant in. Needed some sort of lazy Susan to be able to feed filament out a side wall. Spools did not fit in the bottom of the container well, so I needed to lift them up a little as well. Somewhat unrelated, I intend on getting some weather stripping or paint-on sealant to create a gasket for the lid for a better seal.
Uses a single 608 bearing (not an affiliate link) & does not require support to print.
I have only started 3D printing in the last couple weeks and I have zero knowledge of how to work with CAD. This was all clumsily edited in a slicer. Please don't ask me technical questions lol
I printed it in Elegoo Rapid PLA, 0.2 layer height, 15% infill, changed from 3 walls to 2 after printing the plate and spool to save a minute or two. I don't think it matters much considering the use case.
The spool/plate only fit together in one way as the pegs are not equally spaced :D
Anyway, it works well, and it works even better if you put it in a container that's a litter less restrictive.