IKEA Skadis - Hook / Háček (10mm - 100mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Set of different size hooks for IKEA Skadis board - 3 tolerances for tight fit
- Ocena
- 5 / 5
- Polubienia
- 198
- Pobrania
- 1280
- Wydruki
- 32
- Wyświetlenia
- 3147
- Oceny
- 29
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hooks which I designed from scratch, inspired by “Pavel”. The original hooks didn't work as planned, they were too tight and the “one hook, one pin” design is not good, I also damaged the board in several places when removing the original ones.
This design works with 2 hooks, which is much easier to install and also remove, but holds very well thanks to the small bumps on the hooks:
I made all the sizes from 10mm to 100mm with 5mm increments, so it should be enought for all the use cases.
Print instructions
- I used PLA, but any material should do
- No supports needed
- 4+ perimeters for added stiffness
- 3MF file with all the sizes + 4 perimeters
Update 01/01/2022
I just found out that one of my boards has thickness of 5mm, but the other one has just 4,9mm, meaning the fit is not tight as it should be, so I uploaded new files with hook clearance 4,8mm and for even more tight fit - 4,6mm.
Depending on your board thickness you want to use files:
- 5mm board - 4,9mm hook clearance
- 4,9mm board - 4,8mm hook clearance
- <4,9mm board - 4,6mm hook clearance