earphone cable holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a simple earphone holder to arrange the wire. use it to wind the wire in an “Eighth loop”, put the top and the end of…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 489
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
a simple earphone holder to arrange the wire.
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.
there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;) << size: est. 122x62x13 mm width of the wire holder: 10,4 mm
Print Settings
Rafts:
Yes
Supports:
No
0.1 mm
Infill:
40%
Filament:
any PLA any
Notes:
a simple earphone holder to arrange the wire.
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;) << size: est. 122x62x13 mm width of the wire holder: 10,4 mm
Category: 3D Printing