earphone cable holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
a simple earphone holder to arrange the wire. use it to wind the wire in an “Eighth loop”, put the top and the end of…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 19
- Makes
- 0
- Views
- 489
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
a simple earphone holder to arrange the wire.
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.
there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;) << size: est. 122x62x13 mm width of the wire holder: 10,4 mm
Print Settings
Rafts:
Yes
Supports:
No
0.1 mm
Infill:
40%
Filament:
any PLA any
Notes:
a simple earphone holder to arrange the wire.
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;) << size: est. 122x62x13 mm width of the wire holder: 10,4 mm
Category: 3D Printing