BliKVM v4 & BliSwitch v1 10 inch rack mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows for mounting the BliKVM v4 Allwinner next to the BliSwitch v1 HDMI & USB switch in a 1u 10 inch rack
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 741
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- GNU General Public License v3.0
This allows for mounting the BliKVM v4 Allwinner next to the BliSwitch v1 in a 10 inch rack. Fitment is very tight and you need to have at least 221 mm of horizontal space.
For mounting the BliKVM v4, the included screws can be used. For the right side, a short and thin screwdriver is needed. For mounting the switch, remove the original screws and replace them with two M3x6 FHCS.
There are only 15.8 mm of space between the KVM and the switch, thus you need to get very specific angled cables. Personally, I confirmed that this USB cable (trim the plug by about 1 mm) and this HDMI cable (20 cm CF-HD-L) work. I did not trim the HDMI plug, but it is a very tight fit. You can also break off the third screw location to gain one additional mm. This mounting point is not really needed, just provides a bit more stability. Using such an FFC (A1, A5) might also work and should give some more space, but has not been tested by me.
First fix the switch mount to the BliKVM v4, then push in the switch with cables already connected from the back and screw it in place.