1 / 1
First Gen (1991-1998) Geo/Chevy Tracker Skull Knob For Heat and A/c Controls — zdjęcie 1

First Gen (1991-1998) Geo/Chevy Tracker Skull Knob For Heat and A/c Controls

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I created this for first generation trackers?sidekicks/Suzukis heater A/C control knobs. Real 3d scanned skull.

Ocena
0 / 5
Polubienia
17
Pobrania
252
Wydruki
0
Wyświetlenia
964
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Public Domain

I created this for first generation trackers?sidekicks/Suzukis heater A/C control knobs to be press fit replacements for stock lever knobs. Best done on resin printer but can be done on fdm with small enough nozzle and the right settings for detail. If done on resin printer make sure the skulls are oriented correctly to allow for draining of the slot in the back. the slot point upwards towards the top of the head as it gets deeper to allow for it to sit correctly when installed. If printed in resin just coat them in a UV protective clear coat spray paint or paint them in general to protect them from over curing from the sun. This is a scan of a real skull so the lower jaw can be a weak point.

Probably best resized in your slicer to be 105% or 106% because even though i measured they still came out a little small and even at 104% they fit very very tight.

Tagi