1 / 3
IKEA Skadis - Wrench holder / Držák na klíče — zdjęcie 1
1 / 3

IKEA Skadis - Wrench holder / Držák na klíče

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for 8 wrenches

Ocena
5 / 5
Polubienia
408
Pobrania
2130
Wydruki
56
Wyświetlenia
6579
Oceny
46

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple 2 piece holder for up to 8 wrenches, in my case for 6 - 22mm.

There are 2 models, each with different hook position - offset by 20mm. This means you can put them in any column of holes on the Skadis board, depending on lenght of your wrenches.

Files ends with “1” and “2” for different hook position, print one of each or both the same.

This design works with 2 hooks, which is easy to install and remove, but holds very well thanks to the small bumps on the hooks:

 

Print instructions

  • I used PLA, but any material should do
  • No supports needed
  • 4+ perimeters for added stiffness
  • 3MF file with both models + 6 perimeters

Tagi