Bang & Olufsen Headphone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pegboard holder for headphones, modeled to resemble Bang & Olufsen design language.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a more premium looking display for my headphones, reflective of their excellent design language and feel, than the standard pegboard hooks I was using before.
I have provided both parts of model individually, and as a project which contains the settings I used to print my holder. I would recommend printing the two parts separately, allowing for a colour change on the final few of layers of the earcup base piece, unless you have a multi-material system.
The project contains specific settings for the ear-cup, including variable layer heights, extrusion multipliers and Archimedian chords for the top layer -- these settings replicate the B&O look quite well for this piece, in my opinion.
Please note the tolerances on the dovetail joint are intentionally low! It may take a little persuasion, but no tools should be needed. If you are struggling, ensure the mating surface of the earcup are clear of support interfaces. The pieces are designed to be held together by friction and should not need adhesives.
If your pegboard has a different hole layout, the ear-cup model has a flat base, and so you should be able to easily remove my pegs and model some to fit your board - please remix and share if you do :)