Odroid H3+ standoff screw replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A push-in replacement for a m.2 SSD screw for a standoff with a screw end broken inside
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
I broke a screw in an m.2 standoff on my odroid H3+. I never bothered to send the board around the world for repair, and locked an SSD with a piece of electric tape or some other means. However now with a 3D printer I designed a push-in cover for the standoff that locks the drive in place. I printed it on a standard Bambu P1S settings with supports. The hole that goes over the standoff should be printed upright. My Lexar NM620 is a little bit loose, but I decided not to make adjustments as SSD drives may vary in sizes.
Internal diameter is 5,1 mm, internal hight is 4 mm.