1 / 2
Logitech C270 IKEA Stankregn integration
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for Logitech C270 USB Camera to IKEA Stankregn lamp with optional shared power supply.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This mount allows for integration of Logitech C270 camera with IKEA Stankregn lamp.
Instructions:
- Print both elements, use 0.2mm layer height - it will ensure a single layer bridging when changing mounting holes diameter. Clear holes for M3 screws.
- Disassemble Logitech camera, de-solder shield connection, remove cable and camera PCB.
- Solder the shield connector on the opposite side it was soldered originally.
- Cut a clean filament piece and place it inside the hole for the LED (left side of camera hole)
- Mount the camera PCB to the front plate using two original screws
- Optionally for a common power supply cut IKEA Stankregn cable to a length and solder it to camera PCB power supply rails (5V rail from USB, Stankregn white is +5V, black is GND)
- Slide rubber camera cable mount into a slot in the back piece. and optionally do accordingly with Stankregn cable.
- Screw both pieces using four M3 nuts and M3x10 screws