Sovol SV08 Orca Tuned Profile

####The orca profile here is fine but the klipper config is not only old but has issues in it. I would love to post an updated klipper config that works on .13 klipper but I have moved to mainline, incorporated eddy-ng, and some other tweaks that would be very specific for other users. Unfortunately I have also retired this printer as my bed has a deviation too large to allow for eddy-ng to work so until I solve that issue this printer is shelved. Thank you all for checking out my work and I apologize for any issues you may have found with it and the lack of communication as for some reason I was not getting notified of comments on here.

These are a full set of Orca and Klipper configs to have your SV08 running like a beast right out of the gate. This is mainly geared toward PETG but is working well with PLA,ASA,ABS as well. These configs are paired with a Bambu clone TZ3 Hotend but should work just fine with the stock hotend, run a max flow to check but this can do standard PETG at 24mms/3 at good quality. The Klipper configs are geared toward there being a nevermore in place as well but I do not even have that and it works just fine. I want to ensure the credit to getting this working well is named I would not have this working so well if it were not for the Sovol Discord members Umbra,TomB16, and super special thanks to ss1gohan13, he was instrumental in purchasing the TZ3 hotend as well as a super nice but cheap stainless nozzle.

!!!! Just noticed when I pulled these I had my walls, top and bottom layers and infill set to 0 for a project I am doing so make sure you adjust these or youre gonna get bad prints. I typically start with 3 layers for top and bottom, average 3 walls, infill you should kind of just know what you need at this point lol.