KYB 48mm Fork Shock Adjuster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adjuster for compression on 48mm KYB shocks
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 363
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple tool which uses a slotted ¼" hex bit to adjust the compression clickers on a 48mm KYB shock - Adjusting them using a screwdriver is often difficult because the bars are in the way.
There are 2 models here, 1 for standard 25mm bits, and 1 for shorter, but less common 18mm bits. I used a bit with a face width of 1.1mm (I think this is #2, but not sure)
Print with a pause at 1mm for a layer or two to do multicolor with filament swaps. It prints best top down.
Insert bit. you may need to press it in. if it's loose, use a bit of cyanoacrylate adhesive to retain the bit.
Fusion360 file is included.