KYB 48mm Fork Shock Adjuster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adjuster for compression on 48mm KYB shocks
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 47
- Makes
- 0
- Views
- 363
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple tool which uses a slotted ¼" hex bit to adjust the compression clickers on a 48mm KYB shock - Adjusting them using a screwdriver is often difficult because the bars are in the way.
There are 2 models here, 1 for standard 25mm bits, and 1 for shorter, but less common 18mm bits. I used a bit with a face width of 1.1mm (I think this is #2, but not sure)
Print with a pause at 1mm for a layer or two to do multicolor with filament swaps. It prints best top down.
Insert bit. you may need to press it in. if it's loose, use a bit of cyanoacrylate adhesive to retain the bit.
Fusion360 file is included.