1 / 4
Playstation 5 Dual Sense and Pulse3D Headphone Desktop Stand — zdjęcie 1
1 / 4

Playstation 5 Dual Sense and Pulse3D Headphone Desktop Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple desktop stand for powera twin charging station for ps5 and pulse3d headset

Ocena
0 / 5
Polubienia
7
Pobrania
75
Wydruki
0
Wyświetlenia
853
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

I couldn't find a holder to put my ps5 pulse 3d headset and PowerA Twin charging station and dualsense gamepads, so created one. 

Charger cable slot is a bit large for making charger sliding to adjust easier.

PLA+ 0.20mm layer is enough, make sure 3 walls and 0.8mm bottom and top layer. Infill is not important I think, but I have used %15 cross-hatch. Ironing topmost surface make nice finish. 

Wait for the build plate to cool and release the part, if you bend the plate to remove the part while it is hot, you get a slightly bended headphone holder like mine :)

Print back side flat, I have used tree supports for the charge cable slot and the headrest lip. 

Part is 30cm long, it can be printed on 300x300mm built plate diagonally (for brim and supports) 

 

Tagi