1 / 2
Replacement clip pin for floor register
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed replacement clip in for floor register cover.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
The oak floor registers we purchased had one major flaw - the pin that held the cover against the base was very fragile and broke off leaving the cover loose and the floor register wide open.
I searched high and low for a replacement and could not find one - so I designed a replacement that would work. After a few iterations I think I have one that works very well - with one slight issue… It cannot be printed in PLA (too fragile). I have since printed it in ABS and it is much stronger than the original.