1 / 2
Replacement clip pin for floor register
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printed replacement clip in for floor register cover.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
The oak floor registers we purchased had one major flaw - the pin that held the cover against the base was very fragile and broke off leaving the cover loose and the floor register wide open.
I searched high and low for a replacement and could not find one - so I designed a replacement that would work. After a few iterations I think I have one that works very well - with one slight issue… It cannot be printed in PLA (too fragile). I have since printed it in ABS and it is much stronger than the original.