Makita MakPac 2040 clip-on top frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makita MakPac 2040 top frame. Minimum slack. Tight. Flat. Fits inside the MakPac.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 1688
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Makita MakPac 2040 top frame. Used pieces from a Bear frame Upgrade because thats what I had. Any other profile should work as well.
Minimum slack. Tight. Flat. The handle is still free to be used.
Designed to sit in the grooves and divets in the MakPac lid. If all parts are fitted correctly it will anchor itself in the grooves and the clips only hold it down. Assemble it and use the pieces and box lid itself to find the close positions before assembly. Get the bolts holding but not too tight and make the last corrections before final tightening. The slack is minimized- the box clips may be tighter to get on and off than usual! Some boxes have slightly different dimensions. +-0,0x mm differences on the grooves and divets. One box-one finished frame sits THE best. It should work fine on all other MakPac boxes but there may be some minimal slack in that case. Put some perimeters and full layers on the pieces if you want it stronk!
Flip or turn it around 180 and it fits inside the MakPac! To achieve this, the front bracket holes had to be 1,5 mm off center line to move 2040 closer together. Centered holes made the 2040 too wide and it wont fit in the back of the box. There's a misalignment for a reason. File names have RIGH and LEFT for a identifying.
Parts:
2040 extrusion.
1x 360 mm
2x 206 mm
Used x24 M5. Same amount of T-nuts. Bolt thread length 11,5-12mm. Max head diameter 10 mm (10 mm washer fits in the hole if needed). Head height- there's plenty of room.
2040 end caps- find the one you fancy. There's plenty in the sea. Keep in mind the side bracket has around 2x2 mm space for end cap and the T-nut will sit rather flush with extrusion end. Had to cut side profiles end cap height from 4 to 2 mm and cut bottom holders off to make space for T-nuts.
Great for whatever reason you need 2040 frame sitting tight on top of a MakPac. For example I use it for an OSSM build.