Filament Spool Holder for Table

   If your table also has round legs, you can adjust the mounting diameter in the STEP file, I've provided to fit your table!

   This filament holder is made for my IKEA table (tabletop – LINNMON, legs – ADILS).

The table legs have a diameter of 40.3 mm (+/- 0.2 mm). The shelf holds 6 filament spools. Two shelves fit under one side of the table.

If your table is placed flush against the wall, you will need to move it about 5 cm away from the wall so that the filament spools do not touch the wall.

   To fully assemble one shelf, you will need:

• 8 x M4 Nuts
• 8 x M4x16 Screws
• 2 x Wooden Stick 45 cm (recommended from 16 mm to max. 20 mm diameter)

   And printing:

• 1 x LegMountF
• 1 x SticksMountF
• 1 x LegMountB
• 1 x SticksMountB
• 4 x Cover

(or you can just use my 3MF file with the pre-arranged and prepared parts)

   Difference between parts marked with F (Front) and B (Back):

• F Parts are intended for the front table legs.
• B Parts are intended for the back table legs, making it convenient to screw the bolts with a screwdriver without moving the table for shelf installation.

   Note on bolt compatibility:

There are Wide versions for two parts where the bolt is inserted. They are designed for bolts with a larger head.

For example, I had three types of M4 bolts: one with a head diameter of 6.8 mm, another of 7.5 mm, and another of 7.8 mm. I used the Wide version for the 7.5 mm and 7.8 mm bolts.

Tip: I have prepared a small test model (Test.stl) so you can check if your fasteners will fit before printing the main model! In this test, you can verify if your nuts will fit (I made a snug fit so they won't fall out) and choose the version depending on the head of your bolts.

If you enjoyed this project, please support it with a like!

Updates:

29.12.2024 - V1

• Model release

31.12.2024 - V1.1

• Added the STEP file of the entire project.