Skadis Universal Einhell PowerXChange Charger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Einhell PowerXChange Charger to a IKEA Skadis wall, no supports needed thanks to universal mount hooks
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 137
- Wydruki
- 0
- Wyświetlenia
- 681
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
The ultimate skadis mount for your Einhell PXC charger.
In contrast to other models it uses the universal hooks of CSD_Salzburg and they are placed quite at the top, which allows to take the holder down without needing to break anything. Additionally the pins for the charger mimic countersunk screw heads, which gives a great hold at the mount points of the charger. The dimensions of the pins are chosen in a way that you can't pull them out of the charger, except in the “start”position and the charge sits perfectly snug on the plate without sitting loose and wiggling around.
My models use a rather tight fit on the skadis universal hook, since I prefer when the hook sticks to the holder instead of the pegboard. As such you can usually take the holder off the wall and they will stay in the holder. However you may need to apply a little force when mounting the hooks, but printing the hook in default settings in PLA gives more than enough stability for this little bit of abuse :) If you have problems inserting try going in with the top hook at an angle first, then tilt the lower part in. Finally apply some upwards pressure, e.g. by placing the hook on the edge of a table and pushing the model down gently.
To print this you need additionally two of Skadis_Universal_Hook.stl from https://www.thingiverse.com/thing:2853261/files