Antec Three Hundred Two (302) 3.5" HDD Rail
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement rail for the Antec Three Hundred Two hard drive rail that came with the case.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 319
- Wydruki
- 0
- Wyświetlenia
- 1641
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Antec Case Rail
Replacement rails for an Antec case.
I was repurposing one of my computers to be an Unraid (https://unraid.net/) server, and while moving things around, I broke one of the rails that hold in the hard drives.
I looked at other rail designs, but couldn't find one I liked.
Beyond simply fitting the case, I wanted it to not take screws.
I could not find an existing rail that did both, so I created this rail.
Set the number of vertical perimeters so that the pin is solid plastic.
In my case, this meant increasing the value from 2 to 3 to get a solid pin.
As noted by CircuitGuy in the comments, do use supports when printing.
- Code: https://github.com/AnthonyZ71/antec_case_rail
- STLs: https://www.prusaprinters.org/prints/112341-antec-three-hundred-two-302-35-hdd-rail
References
This OpenSCAD file makes use of the dotSCAD library (https://github.com/JustinSDK/dotSCAD) and assumes it is installed in the system properly.