Hue Play Lightbar Mount v2 for Prusa Mini(+)

Hi,

this is the second version of my Hue Play Lightbar mount. The first one started to sag a lot and I redid the model completly to now feature a hinge.

Everything else pretty much stays the same, but you can now adjust the angle to almost 90 degrees, wich also enables you to put the mount lower on the x-axis, to reduce shaking while printing.

I'm still using the lightbar socket from myit on thingiverse (https://www.thingiverse.com/thing:4735701) to make my life easier.

You will need:

• Phillips Hue Play Lightbar (Base-Kit with power supply, an extension kit is not enough)
• the mounting screw that comes with a lightbar (is probably a M2x8 or something like that)
• 2x M5x16 Screws (non-countersunk)
• 2x M5 Drop-In T-Nuts (whatever fits the 3030 profile. I used some from Amazon, but the forces are not that big, you might also be fine with those: https://www.prusaprinters.org/prints/64627-3030-m5-drop-in-t-nut)
• 1x M4 Screw, 20mm or longer
• 1x M4 Nut

Print Instructions:

• No support for the larger arm part
• Support form print bed for the smaller hinge part, I printed it on the side, for maximum strength, see 3mf
• I used Prusament Jet Black PETG (ASA should also work, PLA might creep, but you could just print it a bit on the thicc side)
• 0.2 layer height
• 20% infill
• 3 or 4 perimeter
• (I was probably way to cautious, less infill and perimeter is probably fine)

Build Instrcutions:

• Attach the arm to the printer
• You'll need to attach the lightbar first before you put the hinge together, because I'm bad at 3D-design.
• The hinge might have a tight fit, because again, I'm bad at 3D-design, but it just worked out for me.