Nikon SP Augenkorrektur; Nikon SP eye correction Dioptienkorrektur eyepiece correction
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nikon SP Augenkorrektur; Nikon SP eye correction Dioptienkorrektur eyepiece correction
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Mit dieser Halterung für die Nikon SP Messsucherkamera kann eine Augenkorrekturlinse aus einer billigen Lesebrille vor dem Okular angebracht werden damit das Sucherbild wieder scharf erscheint.
Für die Auswahl der passenden Stärke eine Lesebrille vor das Okular der Kamera halten und verschieden Stärken ausprobieren bis das Sucherbild scharf erscheint.
Das Brillenglas beidseitig mit einer Folie bekleben um es während der Bearbeitung vor Kratzern zu schützen.
Aus der Mitte des Brillenglases ein rechteckiges Stück mit den Abmessungen 14 x 24 mm aussägen und die vier äußeren Ecken etwas anfasen.
Das ausgeschnittene Stück in die Halterung einsetzen, notfalls abfeilen / anpassen und mit einem winzigen Tropfen Kleber sichern oder die Ränder der Ausnehmung mit einem heißen Schraubenzieher verschmelzen so daß die neue Linse nicht herausfallen kann.
Die Halterung ist in zwei Versionen verfügbar, einmal mit einer 3 mm und einmal mit einer 4 mm Vertiefung für die Linse. Je nachdem wie dick die zugeschnittene Linse ist.
Gedruckt mit PLA ohne besondere Einstellungen
…………………
With this mount for the Nikon SP rangefinder camera, an eye correction lens from a cheap pair of reading glasses can be attached in front of the eyepiece so that the viewfinder image appears sharp again.
To select the right strength, hold a pair of reading glasses in front of the camera's eyepiece and try out different strengths until the viewfinder image appears sharp.
Cover both sides of the lens with a film to protect it from scratches during processing.
Cut out a rectangular piece measuring 14 x 24 mm from the middle of the lens and slightly chamfer the four outer corners.
Insert the cut-out piece into the mount, file / adjust if necessary and secure with a tiny drop of glue or melt the edges of the recess with a hot screwdriver so that the new lens cannot fall out.
The mount is available in two versions, one with a 3 mm and one with a 4 mm deep recess for the lens. Depending on how thick the cut lens is.
Printed with PLA without any special settings