BTT SFS V2 Mount - 2020 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for the BTT Smart Filament Sensor V2 for 2020 extrusions
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a simple 2020 mount for the BTT SFS-V2. I had come across several, but stopped after #4-5, as they were all mounting the sensor in an orientation that wasn't working for me. I wanted my sensor mounted vertically as to allow the PTFE tubing to port into my umbilical entry on the back of my Voron V2.
I suspect I will be revamping this at some point as I've already thought about a few things to reduce the amount of filament used; tolerances on some of the counterbores, etc.
BOM:
M3x8 * 3
M3x12 * 1
M3 HH T-Nut
This will not work with a roll-in t-nut, as there is not enough spacing between the tabs. I might shorten these later to allow for roll-in's but this is where I've landed for now.
Print Settings:
Material - PLA should be fine, but would recommend PETG, ABS or ASA if you are heating the chamber of your printer.
Standard Voron printed part settings is what I use, but most anything within reason would be fine.