1 / 8
FreakyFoot V2 - anti-vibration damper feet (HULA) — zdjęcie 1
1 / 8

FreakyFoot V2 - anti-vibration damper feet (HULA)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My V2 minimized anti-vibration damper feet (based on the HULA seismic damper concept)

Ocena
5 / 5
Polubienia
49
Pobrania
148
Wydruki
2
Wyświetlenia
1827
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is my variant of an anti-vibration damper feet (based on the HULA seismic damper concept). The idea is to damp fast movements only in x and y direction but be stiff in z direction.  

I printed it with ASA, Nozzle 0.4mm, Layer Height of 0.2mm and 5 Perimeters. I have also tried it with PETG or ABS. Use TPU as rubber for the bottom so that your feet don't slip.

Changelog
  • Version 2.2

    • Minor Plastic Spring stability improvement

    • Minor increase of the screw hole size

  • Version 2.1

    • Add additional fillet spring start/end

  • Version 2.0

    • Full redesign of V1

    • Same properties, but  further minimized dimensions

    • TPU Damper is replaced by integrated printed spring

    • Removed V1 description

  • Version 1b

    • Beautifying:

      • Replaced the bottom insert (foot)

      • Replaced the bottom TPU with a less visible one (see comparison picture)

  • Version 1a

    • Initial version

BOM (per foot)
  • 1x M5x16 BHCS Screw

  • 1x Axial ball bearing F8-22M (e.g AliExpress)

Look at the pictures how to assemble the foot. Make sure that you use the axial bearing the wrong way round - the balls must run on the smooth side - not in the actual bearing groove.

Feel free to use longer screws or to add some adapter plates/washers for the printer of your choice as a remix. 

Caution

Be careful not to put your printer on its feet when you tilt it. The springs can withstand vibrations very well, but only minimal stress from the side. Also make sure that the two bearing shells are pressed in cleanly and horizontally, otherwise the feet will not work properly.

 

Love my 3D models? 


If my designs have helped you print something awesome or inspired your next project, consider supporting my work! Your kindness fuels my creativity, keeps the filament rolling, and helps me share even more free/pay-what-you-want models in the future. Every coffee counts! 

→ Buy me a coffee ☕☕☕

Tagi