7mm & 9.5mm SDD/HDD Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made a simple travel/storage case for 7mm and 9.5mm SSDs and HDDs.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 98
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Made a simple travel/storage case for 2.5 inch, 7mm and 9.5mm, SSDs and HDDs.
I recommend to print with TPU or another flexible filament.
Tried different SSDs and HDDs, all fit nice and snug so far.
9.5mm case can be used with 7mm SSDs or HDDs.
Made screw holes mainly to store the screws for the drive itself.
Make sure to clean any stringing on the lid pins and holes for the lid to seat nicely.
I assume you could still use a SATA to USB adapter while the drive is in the case.
No additional hardware needed.
How I printed mine:
- Ender 3 V3 CoreXZ.
- SUNLU 95A TPU at recommended filament settings, did not dry filament.
- 0.32mm layer height at 10% Infill.
- No supports or brims.
- Printed cases standing up with 0.5mm spacing to provide side-by-side support and to mitigate stringing.