1 / 3
Stern Pinball Uncanny X-Men Left Flipper Ball Hop Reducer v2 — zdjęcie 1
1 / 3

Stern Pinball Uncanny X-Men Left Flipper Ball Hop Reducer v2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This helps reduce ball hop from the left inlane guide wire to the left flipper resulting from the wire being too low.

Ocena
0 / 5
Polubienia
5
Pobrania
129
Wydruki
0
Wyświetlenia
601
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

1/15/2025 - Added v2 model. Improvements:

  • More secure fit around the wire guide 
  • Improved height - this should rest just under the flipper rubber, maximizing the ball surface contact zone without digging into or getting damaged by the flipper
  • Longer guide surface - easier to manage alignment. Since it extends over the flipper area the flipper will push it into close to ideal position. Just nudge this guide surface slightly to ensure the ball rolls gently down to the flipper rubber. 
  • Tested with better filament (ASA) instead of PLA. PLA isn't ideal for this since it generally lacks the flexibility to stretch around and then clamp securely around the wire. I would expect PETG and ABS to be good options, as well.  TPU would be an interesting test. 

Due to manufacturing tolerance issues, many of the left inlane guide wires on Stern Pinball's The Uncanny X-Men game sit a tiny bit too low in relation to the flipper. When the ball rolls down the guide wire, it is lower than the top of the flipper rubber, so the ball bounces when it hits that rubber instead of rolling smoothly down the flipper. 

I have been able to reduce this ball hop greatly with this part. Snap this to the left inlane guide wire post that goes into the playfield closest to the left flipper. Rotate it so that the flat platform rests just above the flipper rubber, then roll the ball back and forth a few times to ensure that it isn't bouncing as much. 

This probably won't help too much with the ball bouncing when dropping from the left wireform/Cerebro. Some of that is related to the impact of the ball falling and having a natural bit of bounce. That can usually be mitigated by simply trapping the ball with the flipper. 

Video examples of ball hop/bounce available at:
Stern Pinball Uncanny X-Men Left Flipper Ball Hop Examples

I've tested these designs successfully on my game, which uses standard size Titan Competition flipper rubbers. Adjusting the scale, reducing the Z-axis size, etc. may be required depending on the tolerances of your game. If you use stock natural rubber, it should be fine for those, as well, but I haven't tested with Titan low bounce flipper rubbers. Those are slightly thinner, and this should work just fine with them, as well, as long as you've got this piece angled correctly. 

 

Tagi