1 / 3
Emergency Stop Button Replacement Bottom
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I modeled this up as a replacement to my E-Stop button because the place that the cord goes in had a fragile rubber seal that easily broke leaving a huge hole. This has a much smaller hole so that a cord can just go out the side. That way I didn't need to buy a completely new button just for this little problem.
Update: I had one of the screw hole posts break off on me, so I reinforced it against the side wall so it shouldn't happen again.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
0.20
Infill:
20
Filament:
Prusament PLA Black
Category: DIY