1 / 3
Emergency Stop Button Replacement Bottom
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
I modeled this up as a replacement to my E-Stop button because the place that the cord goes in had a fragile rubber seal that easily broke leaving a huge hole. This has a much smaller hole so that a cord can just go out the side. That way I didn't need to buy a completely new button just for this little problem.
Update: I had one of the screw hole posts break off on me, so I reinforced it against the side wall so it shouldn't happen again.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
No
Supports:
No
0.20
Infill:
20
Filament:
Prusament PLA Black
Category: DIY