Thrustmaster T3PA Pedal Vibration Motor Mount

So... on the back of the T3PA pedals, there is an unused mounting hole behind the Throttle pedal...?

Perfect for mounting up a vibration motor I'd hot glued into a 25mm conduit saddle mount clip hey?

It's a mod I'd done with an arduino to feel vibration when I'd locked up wheels with ABS or sliding due to excessive drifting skillz... etc.

Anywho... You'll see the way I'd mounted the vibration motor I'd stripped out of an old gamepad. I used a 5mm bolt and nut to clamp this to the bracket and two 3mm pk screws into the pedal base.

Keep the 3mm screws into the pedal base fairly short.. no more than about 5mm deep?

Check out my mods and other work at oznzsimracing.com

here - http://oznzsimracing.com/forums/m/16887284/viewthread/29285694-3d-modellingprinting-sketchup-fusion360

here - http://oznzsimracing.com/forums/m/16887284/viewthread/29305339-pagnian-gt-ultimate-wheel-stand-problems-fixes

and here - http://oznzsimracing.com/forums/m/16887284/viewthread/23526371-ramjetx-simrig-other-stuff

Print Settings

Printer Brand:

Wanhao

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm worked fine

Infill:

Notes:

Nothing special.. no supports needed. It's supposed to vibrate and transfer vibration energy to the pedal base... so more infill the better really for transmitting vibration. 20% seems fine.

Category: Hobby