Thrustmaster T3PA Pedal Vibration Motor Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
So... on the back of the T3PA pedals, there is an unused mounting hole behind the Throttle pedal...?
Perfect for mounting up a vibration motor I'd hot glued into a 25mm conduit saddle mount clip hey?
It's a mod I'd done with an arduino to feel vibration when I'd locked up wheels with ABS or sliding due to excessive drifting skillz... etc.
Anywho... You'll see the way I'd mounted the vibration motor I'd stripped out of an old gamepad. I used a 5mm bolt and nut to clamp this to the bracket and two 3mm pk screws into the pedal base.
Keep the 3mm screws into the pedal base fairly short.. no more than about 5mm deep?
Check out my mods and other work at oznzsimracing.com
and here - http://oznzsimracing.com/forums/m/16887284/viewthread/23526371-ramjetx-simrig-other-stuff
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
No
Supports:
No
0.2mm worked fine
Infill:
20%
Notes:
Nothing special.. no supports needed. It's supposed to vibrate and transfer vibration energy to the pedal base... so more infill the better really for transmitting vibration. 20% seems fine.
Category: Hobby