Filament Rack Bracket w/Endcaps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A load simulation tested bracket Holds up to 29.3 Kg the screws will fail before the bracket STL and 3mf included
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a load tested bracket, I simulated a much higher load than filament would ever exert, my personal setup holds up to 13 rolls of 1Kg filament rolls, with the addition of more brackets it can be extended , The diameter of the rod fixture is 25.5mm , so it can be used with thinner rods and up to 26mm rods, I used an old rod from a Microphone boom arm for my rod, a broom handles may work or a wooden dowel rod, anything that doesn't bend easily. Load tested in simulation up to 29.3Kg, the screws will fail before the bracket, YMMV I assume no responsibility if your brackets fail at 26Kg or something lower